Faber Repair Service in Millfield

What does a steady LED light mean on a Faber cooker hood?

A steady LED light on a Faber cooker hood indicates that the metal grease filters need cleaning. This alarm activates after approximately 100 hours of operation. Remove the filters and wash them by hand or in the dishwasher, then reset the alarm by pressing and holding the reset button for 3-4 seconds until the LEDs flash three times.

Why is my Faber cooker hood making excessive noise or vibrating?

Excessive noise or vibration from a Faber cooker hood is commonly caused by incorrect installation, undersized ducting, or a loose mounting. Verify the hood is securely fixed and that ducting maintains the recommended diameter throughout the entire run without kinks or restrictions. Dirty filters can also increase noise levels. If vibrations persist after checking installation, contact a qualified technician as the motor or impeller may require inspection.

Why is my Faber cooker hood not extracting properly?

Reduced extraction on a Faber cooker hood is usually caused by clogged filters, blocked ducting, or stuck damper flaps. Clean the grease filters thoroughly, replace charcoal filters for recirculation hoods, check the exterior vent for blockages, and ensure ducting is not kinked. If suction remains weak, contact a qualified technician.

Why is my Faber cooker hood motor humming but not spinning?

If your Faber cooker hood motor hums but the fan does not spin, this typically indicates a faulty start capacitor or a seized motor. Switch off the hood at the mains immediately and do not continue using it in this condition. Symptoms may vary by model, so consult your instruction manual for model-specific guidance. Contact a qualified technician for diagnosis and repair.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

What cleaning products should I avoid using on my Faber cooker hood?

Avoid using alcohol-based or silicone-based products to clean the inside or outside of your cooker hood, as these can damage the finish. Never use abrasive cleaners, scouring pads, or products containing chlorine. Use only mild soap with a soft cloth or sponge.

What are the benefits of LED lighting in Faber cooker hoods?

LED lighting in Faber cooker hoods provides bright, even illumination across the entire cooking area while using significantly less energy than traditional halogen bulbs. LEDs also have a much longer lifespan and produce less heat, contributing to the overall energy efficiency of the hood.

What does the flashing light on my Faber cooker hood mean?

A flashing light on a Faber cooker hood typically indicates a filter maintenance alarm. A steady or slow-flashing light signals that the grease filters need cleaning (activated after approximately 100 hours of use), while a faster flash indicates the charcoal filters need replacing (activated after approximately 200 hours).

What is the minimum installation height for a Faber cooker hood above a gas hob?

The minimum distance between the cooker hood and a gas hob must be at least 75cm. This increased distance is required due to the open flames and heat production from gas burners.

Why is my Faber cooker hood noisy?

Noise is generated by the airflow passing through the grease filters during operation. Common causes of increased noise include dirty or clogged filters, undersized ducting, or obstructions in the duct run. Clean or replace filters regularly and ensure ducting is the correct diameter throughout the entire run.