Faber Repair Service in Ravensthorpe and Walton

Why are all LED buttons flashing twice on my Faber cooker hood?

When all LED buttons flash twice simultaneously on a Faber cooker hood, it indicates that the control lock mode has been activated or deactivated. This safety feature prevents accidental changes to hood settings during cleaning. To toggle the lock, press and hold the designated button according to your model's instructions. This is a confirmation signal, not an error.

Why are the lights not working on my Faber cooker hood?

If the lights on your Faber cooker hood do not illuminate but the motor works, it may be a bulb, LED strip, or driver failure. Switch off at the mains before any inspection. For halogen models, you may check and replace the bulb with a matching type, avoiding direct skin contact with the new bulb. For LED models, contact a qualified technician as LED components require technical expertise to replace. Consult your instruction manual for model-specific bulb specifications.

Why does my Faber cooker hood turn on by itself?

If your Faber cooker hood turns on automatically without manual activation, it is likely equipped with a heat sensor that detects high temperatures from your hob. This safety feature activates the extraction fan when excess heat builds up, helping to remove smoke and prevent overheating. Some models also feature K-Link technology that synchronises the hood with a compatible Faber induction hob, automatically adjusting extraction based on cooking intensity. This is normal operation for hoods with these features.

Why does my Faber cooker hood turn off automatically after 30 minutes?

If your Faber cooker hood switches off automatically after 30 minutes, the delay function is active. This feature allows the hood to continue extracting residual cooking odours after you finish cooking, then shuts off automatically. To deactivate this function, press and hold the delay button for approximately 3 seconds according to your model's instructions. This is a programmed feature, not a malfunction.

What does a single LED flash mean on a Faber cooker hood?

A single LED flash on a Faber cooker hood indicates that the remote control receiver has been deactivated. To reactivate the remote control, press the same button for approximately 5 seconds until the LED flashes twice to confirm activation.

How do I calculate the extraction rate I need for my Faber cooker hood?

Calculate your required extraction rate by multiplying your kitchen volume (in cubic metres) by 10. For example, a kitchen measuring 5m × 3m × 3m equals 45 cubic metres, requiring a minimum extraction rate of 450 m³/h.

What noise level should I expect from a Faber cooker hood?

A comfortable cooker hood should not exceed 55 dB(A) at maximum speed during normal operation. Faber hoods are designed to minimise noise through optimised internal airflow and components. Models with brushless motors and the Eco function can operate below 40 dB(A) for continuous air circulation.

What is the minimum installation height for a Faber cooker hood above an electric or induction hob?

The minimum distance between the cooker hood and an electric or induction hob is 65cm. If the hob has a larger cooking area, the hood may need to be positioned slightly higher to provide complete coverage.

How do I clean the exterior of my Faber cooker hood?

Clean the hood exterior with a damp sponge or cloth and a small amount of mild soap. Rinse thoroughly and dry with a soft cloth. For stainless steel models, finish with a stainless steel polish.

What types of charcoal filters are available for Faber cooker hoods?

Faber offers several types of charcoal filters for recirculating hoods: standard activated carbon filters (replace every 3-4 months), high-performance activated carbon filters (replace every 6 months), and Long Lasting filters (wash in the dishwasher every 3-4 months, lasting up to 3 years). Check your model's specifications for compatible filter types.